Required Tools, Wires, And Cables - Juniper ERX - RELEASE 11.1.X HARDWARE GUIDE 03-23-2010 Hardware Manual

ERX 11.1.x Hardware Guide
Figure 23: ERX Ports and Connectors (ERX14xx Model Shown)

Required Tools, Wires, and Cables

Cabling your system takes only a few minutes. You need the following items and
those listed in Table 6 on page 49 for proper installation:
48

Required Tools, Wires, and Cables

1/8–inch flathead screwdriver
3/8–inch wrench or 3/8–inch nut-driver
No. 2 Phillips screwdriver
Ground wires We recommend a minimum of 10-AWG ground wire.