Unpacking And Inspecting Erx Routers; Before You Begin; Unpacking Erx14Xx Models - Juniper ERX - RELEASE 11.1.X HARDWARE GUIDE 03-23-2010 Hardware Manual

Chapter 2

Unpacking and Inspecting ERX Routers

Before You Begin

Unpacking ERX14xx Models

This chapter reviews shipping contents and unpacking procedures for ERX routers.
It contains the following sections:
Before You Begin on page 21
Unpacking ERX14xx Models on page 21
Unpacking ERX7xx Models and ERX310 Broadband Services Routers on page 22
Inspecting Router Components and Accessories on page 22
If You Detect or Suspect Damage on page 23
Contacting Juniper Networks on page 23
The Next Step on page 23
Before you begin unpacking the router, be sure you have the following tools:
A No. 2 Phillips screwdriver
A utility knife
A mechanical lift, or at least two people to assist in lifting
ERX14xx models come boxed, bolted, and strapped to a skid. For your convenience,
we recommend that you unpack the router in the location where you want to install
it.
WARNING: Three people are required to install the router in a rack: two to lift the
system into position and one to screw it to the rack.
To unpack ERX14xx models:
Cut the two straps that secure the carton to the skid, open the carton from the
1.
top, and remove the box of accessories that sits on top of the router.
Unlock the four plastic clips that hold the box to the skid by squeezing them in
2.
their center and pulling out, and then lift the carton off the router.
21
Before You Begin