ERX 11.1.x Hardware Guide
3.
4.
Figure 13: Removing an L-Bracket
Unpacking ERX7xx Models and ERX310 Broadband Services Routers
ERX7xx models and ERX310 routers are shipped boxed, but not attached to a skid.
For your convenience, we recommend that you unpack the router in the location
where you want to install it.
To unpack an ERX7xx model or an ERX310 router:
1.
2.
3.
WARNING: Three people are required to install the router in a rack: two to lift the
system into position and one to screw it to the rack.
Inspecting Router Components and Accessories
After you remove the equipment from the shipping containers:
22
Unpacking ERX7xx Models and ERX310 Broadband Services Routers
Remove the three screws that attach each of the two L-brackets to the router.
To avoid scratching the router when removing it from the skid, detach one of
the L-brackets from the skid by removing the three screws. See Figure 13 on
page 22.
Open the carton from the top.
Remove the box of accessories that sits on top of the system.
Remove the router from the box.