Configuring Line Module Redundancy; The Next Step - Juniper ERX - RELEASE 11.1.X HARDWARE GUIDE 03-23-2010 Hardware Manual

ERX 11.1.x Hardware Guide
2.

Configuring Line Module Redundancy

For information about configuring line module redundancy, see JUNOSe System Basics
Configuration Guide, Chapter 6, Managing Modules.

The Next Step

After you install the modules, you can connect cables to the system. See "Cabling
ERX Routers" on page 47.
46

Configuring Line Module Redundancy

The system reboots.
Issue the show redundancy command, and verify that the display shows the
redundancy hardware.