Telnet Setup - Juniper ERX - RELEASE 11.1.X HARDWARE GUIDE 03-23-2010 Hardware Manual

ERX 11.1.x Hardware Guide
3.
After you have assigned an IP address to the system, you can communicate remotely
by running Telnet over an Ethernet network. See "Telnet Setup" on page 72.

Telnet Setup

After you have configured an IP address for the system, you can run Telnet from a
host to access the system through its Ethernet port. To connect the Ethernet port to
the network:
1.
2.
Before you can access the system with Telnet, you must either configure a password
for Telnet access or disable the password requirement from the management console.
In the following example, you disable the password.
1.
2.
3.
4.
72
Telnet Setup
Use an IP address valid for the system.
host1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#interface FastEthernet slotnumber/0
host1(config-if)#ip address 10.10.7.3 255.255.255.0
Continue to configure the system's parameters as needed.
Connect an Ethernet cable (RJ-45) to the system's 10/100Base-T (RJ-45) port on
the SRP I/O module.
Connect the other end of the cable to the appropriate Ethernet network for an
out-of-band connection.
Enter the enable command.
host1>enable
host1#
The system is now in Privileged Exec mode.
Enter the configure command.
host1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#
The system is now in Global Configuration mode.
Enter the line command.
host1(config)#line vty 0 4
host1(config-line)#
The system is now in Line Configuration mode.
Disable the password.
host1(config-line)#no login