Installing An Srp Module - Juniper ERX - RELEASE 11.1.X HARDWARE GUIDE 03-23-2010 Hardware Manual

ERX 11.1.x Hardware Guide
NOTE: See the figures in "ERX Overview" on page 3 for module locations.
5.
CAUTION: Do not overtighten the screws.

Installing an SRP Module

To install an SRP module:
1.
NOTE: See the figures in "ERX Overview" on page 3 for module locations.
2.
3.
4.
5.
38
Installing SRP I/O and SRP Modules
Tighten the module's captive screws using a No. 2 Phillips screwdriver. Turn
both screws several times before tightening them completely to allow the module
to sit correctly.
Ground yourself by using an antistatic wrist strap or other device and connect
it to the ESD grounding jack on the chassis.
Choose the slot in which you want to install the module.
ERX14xx models Slot 6 or 7
ERX7xx models Slot 0 or 1
ERX310 router Slot 0
With a No. 2 Phillips screwdriver, loosen the captive screws that secure the blank
filler panel covering the empty chassis slot, if present, and remove the filler
panel.
Remove the SRP module from its antistatic bag, being careful not to touch module
components, pins, leads, or solder connections.
Verify that the ejectors are in the open position, as shown in Figure 20 on
page 39.