This enables the system to support application images greater than 172 MB. For
example, you cannot go from Release 5.1.1 to Release 7.2.0 without first upgrading
to Release 5.1.2. See the following table for compatibility of releases.
JUNOSe Release
5.1.1 or lower-numbered release
5.1.2 or higher-numbered release
7.2.0 or higher-numbered release
Your software upgrades may be available remotely through Telnet or FTP, or may
be delivered on a new NVS card. Depending on how you access the software updates,
there are two different procedures to follow. For more detailed information on
installing software, and about NVS cards and SRP modules, see:
Upgrading NVS Cards on SRP Modules
This section describes how to install higher-capacity NVS cards on SRP modules. The
procedure you use depends on the number of SRP modules in the system. A new
NVS card already contains the software release you ordered.
NOTE: The new NVS card must contain the same software release that you are
running on the system.
Upgrading a System That Contains One SRP Module
If the system contains only one SRP module, you must power down the system
before you upgrade the NVS card.
CAUTION: If you do not use the halt command before removing or powering down
an SRP module, the system's NVS card can become corrupted.
To upgrade the NVS card on a system that contains one SRP module:
Highest Release Able to Load
5.3.5p0-2 or the
highest-numbered 5.x.x release
No limitation
No limitation
JUNOSe System Basics Configuration Guide, Chapter 6, Managing Modules
Upgrading NVS Cards on SRP Modules on page 79
Chapter 8: Maintaining ERX Routers
Cannot Load
6.x.x or higher-numbered
release
Not applicable
Not applicable
Upgrading NVS Cards on SRP Modules
Maximum Application
Image
~172 MB
~234 MB
~256 MB
79