Powering The Idsm2 Up And Down; Catalyst Software - Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual

Chapter 7 Installing the IDSM2

Powering the IDSM2 Up and Down

You can remove and restore power to the IDSM2 through the switch CLI. This section describes how to
power the IDSM2 up and down through the switch CLI, and contains the following sections:
•
•

Catalyst Software

Once you power off the IDSM2, you must power it up through the switch CLI.
The IDSM2 CLI reset powerdown command performs a shut down, but does not remove power from
Note
the IDSM2.
To power the IDSM2 up and down from the switch CLI, follow these steps:
Log in to the console.
Step 1
Enter privileged mode.
Step 2
console> enable
Step 3 Power up the IDSM2.
console> (enable) set module power up module_number
Power down the IDSM2.
Step 4
console> (enable) set module power down module_number
OL-18504-01
Catalyst Software, page 7-15
Cisco IOS Software, page 7-16
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
Powering the IDSM2 Up and Down
7-15