Cisco Ios Software; Resetting The Idsm2; Catalyst Software - Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual

Chapter 7 Installing the IDSM2
The set boot device command can either contain cf:1 or hdd:1.
Reset the IDSM2. The full memory test runs.
Step 4
Note

Cisco IOS Software

Use the hw-module module module_number reset mem-test-full command to enable a full memory
test. The full memory test takes about 12 minutes. To enable a full memory test, follow these steps:
Log in to the console.
Step 1
Enable the full memory test.
Step 2
router# hw-module module 9 reset mem-test-full
router#
Step 3 Reset the IDSM2. The full memory test runs.
Note

Resetting the IDSM2

If for some reason you cannot communicate with the IDSM2 through SSH, Telnet, or the switch session
command, you must reset the IDSM2 from the switch console. The reset process requires several
minutes. This section describes how to reset the IDSM2, and contains the following topics:
•
•

Catalyst Software

To reset the IDSM2 from the CLI, follow these steps:
Log in to the console.
Step 1
Enter privileged mode.
Step 2
console> enable
OL-18504-01
A full memory test takes more time to complete than a partial memory test.
Device BOOT variable for reset = <empty>
Warning: Device list is not verified.
Proceed with reload of module?[confirm]
% reset issued for module 9
A full memory test takes more time to complete than a partial memory test.
Catalyst Software, page 7-13
Cisco IOS Software, page 7-14
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
Resetting the IDSM2
7-13