Deleting A License From A Management Center; Powering Down The Appliance; Shipping Considerations - Cisco 7010 Installation Manual

Appendix E Preconfiguring Firepower Managed Devices

Deleting a License from a Management Center

Use the following procedure if you need to delete a license for any reason. Keep in mind that, because
Cisco generates licenses based on each Management Center's unique license key, you cannot delete a
license from one Management Center and reuse it on a different Management Center. For more
information, see See Licensing the Firepower System in the Firepower Management Center
Configuration Guide.
To delete a license:
Select
Step 1
Next to the license you want to delete, click the delete icon (
Step 2
Deleting a license removes the licensed capability from all devices using that license. For example, if
your Protection license is valid and enabled for 100 managed devices, deleting the license removes
protection capabilities from all 100 devices.
Confirm that you want to delete the license.
Step 3
The license is deleted.

Powering Down the Appliance

Use the following procedures to power down the appliance safely before disconnecting the power supply.
To power down a Firepower device:
On the device, enter the following at the command line:
Step 1
system shutdown
The device shuts down safely.

Shipping Considerations

To prepare the appliance for shipment to the target location, you must safely power down and repackage
the appliance. Keep in mind the following considerations:
•
•
•
•
Access: Admin
.
Systems > Licenses
Admin
Access:
Use the original packaging to repack the appliance.
Include all reference material and power cords with the appliance.
Protect the NetMods and SFPs from damage caused by improper handling or undue pressure.
Provide all setting and configuration information to the target location, including the new password
and the detection mode.
Preparing the Appliance for Shipment
).
Firepower 7000 and 8000 Series Installation Guide
E-5