Powering On The Cisco Asa 5505; Setting Up A Pc For System Administration - Cisco ASA 5505 Getting Started Manual

Powering on the Cisco ASA 5505

Powering on the Cisco ASA 5505

Step 1
Step 2
Step 3
Step 4

Setting Up a PC for System Administration

Step 1
Cisco ASA 5505 Getting Started Guide
4-6
To power on the Cisco ASA 5505, perform the following steps:
Connect the power supply to the power cable.
Connect the small, rectangular connector of the power supply cable to the power
connector on the rear panel.
Connect the AC power connector of the power supply input cable to an electrical
outlet.
The Cisco ASA 5505 does not have a power switch. Completing Step
Note
powers on the device.
Check the power LED; if it is solid green, then the device is powered on.
For more information, see the
You can perform setup, configuration, and management tasks from a PC using the
Adaptive Security Device Manager (ASDM) application, which provides an
intuitive graphical user interface (GUI). In addition to configuration and
management capability, ASDM also provides configuration wizards for initial
configuration, VPN configuration, and high-availability configuration.
For more information about using ASDM for setup and configuration, see
Chapter 5, "Configuring the Adaptive Security Appliance."
To set up a PC from which you can configure and manage the Cisco ASA 5505,
perform the following steps:
Make sure that the speed of the PC interface to be connected to one of the Cisco
ASA 5505 inside ports is set to autonegotiate. This setting provides the best
performance.
Chapter 4
"Front Panel Components" section on page
Installing the ASA 5505
3
4-9.
78-17612-02