Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual page 212

Advanced Setup
Subinterface Number: 9
Description[Created via setup by user asmith]:
Vlans[]:
Enter
d.
Note
Repeat Steps c and d until you have added all VLAN groups.
e.
Press Enter at a blank subinterface line to return to list of interfaces available for VLAN groups.
f.
Option:
Press Enter to return to the top-level interface configuration menu.
Step 10
[1] Remove interface configurations.
[2] Add/Modify Inline Vlan Pairs.
[3] Add/Modify Promiscuous Vlan Groups.
[4] Add/Modify Inline Interface Pairs.
[5] Modify interface default-vlan.
Option:
Press Enter to return to the top-level menu.
Step 11
[1] Edit Interface Configuration
[2] Edit Virtual Sensor Configuration
[3] Display configuration
Option:
Enter
Step 12
[1] Remove vs
[2] Modify "vs0"
[3] Create new vs
Option:
Enter
Step 13
Virtual Sensor: vs0
Anomaly Detection: ad0
Event Action Rules: rules0
Signature Definitions: sig0
No Interfaces to remove.
Unassigned:
Promiscuous:
[1] GigabitEthernet0/7
Enter
Step 14
Promiscuous Vlan Groups:
[2] GigabitEthernet0/8:10
[3] GigabitEthernet0/8:9
Add Interface:
Step 15 Press Enter to return to the top-level virtual sensor configuration menu.
Virtual Sensor: vs0
Anomaly Detection: ad0
Event Action Rules: rules0
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
10-22
to assign VLANs 1-100 to subinterface 9.
1-100
This removes VLANs 1-100 from the unassigned VLANs contained in subinterface 10.
[1] GigabitEthernet0/7
[2] GigabitEthernet0/8
to edit the virtual sensor configuration.
2
to modify the virtual sensor vs0 configuration.
2
to add VLAN group GigabitEthernet0/8:10 to the virtual sensor vs0.
2
(Vlans: unassigned)
(Vlans: 1-100)
Chapter 10 Initializing the Sensor
OL-18504-01