Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual page 345

Intrusion prevention system appliance and module installation guide for ips 7.0
Table of Contents

Advertisement

Chapter A
Troubleshooting
Health and Status Information
To see the general health of the AIP SSM, use the show module 1 details command:
asa# show module 1 details
Getting details from the Service Module, please wait...
ASA 5500 Series Security Services Module-20
Model:
Hardware version:
Serial Number:
Firmware version:
Software version:
Status:
Mgmt IP addr:
Mgmt web ports:
Mgmt TLS enabled:
asa#
The output shows that the AIP SSM is up. If the status reads
the hw-module module 1 reset command:
asa# hw-module module 1 reset
The module in slot 1 should be shut down before
resetting it or loss of configuration may occur.
Reset module in slot 1? [confirm]
Reset issued for module in slot 1
asa(config)# show module
Mod Card Type
--- -------------------------------------------- ------------------ -----------
0 ASA 5520 Adaptive Security Appliance
1 ASA 5500 Series Security Services Module-10
Mod MAC Address Range
--- --------------------------------- ------------ ------------ ---------------
0 000b.fcf8.7bdc to 000b.fcf8.7be0
1 000b.fcf8.0176 to 000b.fcf8.0176
Mod Status
--- ------------------
0 Up Sys
1 Shutting Down
****************************************************
asa(config)# show module
Mod Card Type
--- -------------------------------------------- ------------------ -----------
0 ASA 5520 Adaptive Security Appliance
1 ASA 5500 Series Security Services Module-10
Mod MAC Address Range
--- --------------------------------- ------------ ------------ ---------------
0 000b.fcf8.7bdc to 000b.fcf8.7be0
1 000b.fcf8.0176 to 000b.fcf8.0176
Mod Status
--- ------------------
0 Up Sys
1 Up
asa(config)#
OL-18504-01
ASA-SSM-20
0.2
P2B000005D0
1.0(10)0
5.1(0.1)S153.0
Up
10.89.149.219
443
true
Hw Version
0.2
0.2
Hw Version
0.2
0.2
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
Troubleshooting the AIP SSM
, you can reset the AIP module using
Down
Model
Serial No.
ASA5520
P2A00000014
ASA-SSM-10
P2A0000067U
Fw Version
Sw Version
1.0(10)0
7.0(1)
1.0(10)0
5.1(0.1)S153.0
Model
Serial No.
ASA5520
P2A00000014
ASA-SSM-10
P2A0000067U
Fw Version
Sw Version
1.0(10)0
7.0(1)
1.0(10)0
5.1(0.1)S153.0
A-67

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents