Verifying Installation - Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual

Verifying Installation

Verifying Installation

Use the show inventory command in privileged EXEC mode to verify the installation of the AIM IPS.
You can also use this command to find the serial number of your AIM IPS for use in troubleshooting
Note
with TAC. The serial number appears in the PID line, for example, SN: FOC11372M9X.
To verify the installation of the AIM IPS, follow these steps:
Log in to the router.
Step 1
Step 2 Enter privileged EXEC mode on the router.
router> enable
Step 3 Verify that the AIM IPS is part of the router inventory.
router# show inventory
NAME: "3825 chassis", DESCR: "3825 chassis"
PID: CISCO3825 , VID: V01 , SN: FTX1009C3KT
NAME: "Cisco Intrusion Prevention System AIM in AIM slot: 1", DESCR: "Cisco Intrusion
Prevention"
PID: AIM IPS-K9 , VID: V01 , SN: FOC11372M9X
router#
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
5-6
Chapter 5 Installing the AIM IPS
OL-18504-01