Logging In To The Idsm2 - Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual

Logging In to the IDSM2

Logging In to the IDSM2
You must initialize the IDSM2 (run the setup command) from the switch. After networking is
Note
configured, SSH and Telnet are available.
You log in to the IDSM2 from the switch. To session in to the IDSM2, follow these steps:
Session to the IDSM2 from the switch:
Step 1
•
•
Step 2 Enter your username and password at the login prompt.
Note
login: cisco
Password:
***NOTICE***
This product contains cryptographic features and is subject to United States and local
country laws governing import, export, transfer and use. Delivery of Cisco cryptographic
products does not imply third-party authority to import, export, distribute or use
encryption. Importers, exporters, distributors and users are responsible for compliance
with U.S. and local country laws. By using this product you agree to comply with
applicable laws and regulations. If you are unable to comply with U.S. and local laws,
return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to export@cisco.com.
***LICENSE NOTICE***
There is no license key installed on the system.
Please go to http://www.cisco.com/go/license to obtain a new license or install a license.
IDSM2#
For More Information
For the procedure for using the setup command to initialize the IDSM2, see
IDSM2, page
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
9-8
For Catalyst software
console> (enable) session slot_number
For Cisco IOS software
router# session slot_number processor 1
The default username and password are both cisco. You are prompted to change them the first
time you log in to the IDSM2.You must first enter the UNIX password, which is cisco. Then you
must enter the new password twice.
10-20.
Chapter 9 Logging In to the Sensor
Advanced Setup for the
OL-18504-01