Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual page 260

Installing System Images
Default boot [disk]>
Number cores [2]>
ServicesEngine boot-loader >
For each prompt, enter a value or accept the previously stored input that appears inside square brackets
by pressing Enter.
Note
Note
The pathname for the AIM IPS image is full but relative to the tftp server root directory (typically
Caution
/tftpboot).
Start the bootloader.
Step 11
ServicesEngine bootloader> upgrade
Follow the bootloader instructions to install the software (choose option 1 and follow the wizard
Step 12
instructions).
Note
Example
Booting from flash...please wait.
Please enter '***' to change boot configuration:
11 ***
ServicesEngine boot-loader Version : 1.1.0
ServicesEngine boot-loader > config
IP Address [10.1.9.201]>
Subnet mask [255.255.255.0]>
TFTP server [10.1.9.1]>
Gateway [10.1.9.1]>
Default boot [disk]>
Number cores [2]>
ServicesEngine boot-loader > upgrade
Cisco Systems, Inc.
Services engine upgrade utility for AIM IPS
-----
Main menu
1 - Download application image and write to USB Drive
2 - Download bootloader and write to flash
3 - Download minikernel and write to flash
r - Exit and reset card
x - Exit
Selection [123rx]
Download recovery image via tftp and install on USB Drive
TFTP server [10.1.9.1]>
full pathname of recovery image []:IPS-AIM-K9-sys-1.1-7.0-1-E3.img
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
12-24
The gateway IP address must match the IP address of the IDS-Sensor slot/port interface.
If you set up the module interfaces using the unnumbered command, the gateway IP address
should be the IP address of the other router interface being used as part of the unnumbered
command.
In the following example, the AIM IPS IP address is 10.1.9.201. The imaging process accesses
the AIM IPS image from the router TFTP server at IP address 10.1.9.1.
Chapter 12 Upgrading, Downgrading, and Installing System Images
OL-18504-01