Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual page 320

Troubleshooting the Appliance
-----------------------------------------------
user-profiles (min: 0, max: 250, current: 1)
-----------------------------------------------
-----------------------------------------------
cat6k-devices (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
router-devices (min: 0, max: 250, current: 1)
-----------------------------------------------
-----------------------------------------------
firewall-devices (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
sensor(config-net)#
Step 3 Manually connect to the device to make sure you have used the correct username, password, and enable
password, and to ensure that the device is reachable from the sensor.
Log in to the service account.
a.
Telnet or SSH to the network device to verify the configuration.
b.
c. Make sure you can reach the device.
d. Verify the username and password.
Step 4 Verify that each interface and direction on each network device is correct.
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
A-42
-----------------------------------------------
-----------------------------------------------
never-block-hosts (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
never-block-networks (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
block-hosts (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
block-networks (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
profile-name: r7200
-----------------------------------------------
enable-password: <hidden>
password: <hidden>
username: netrangr default:
-----------------------------------------------
ip-address: 10.89.147.54
-----------------------------------------------
communication: telnet default: ssh-3des
nat-address: 0.0.0.0 <defaulted>
profile-name: r7200
block-interfaces (min: 0, max: 100, current: 1)
-----------------------------------------------
interface-name: fa0/0
direction: in
-----------------------------------------------
pre-acl-name: <defaulted>
post-acl-name: <defaulted>
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
Chapter A Troubleshooting
OL-18504-01