Installing The Ips 4270-20 In The Rack - Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual

Chapter 4 Installing the IPS 4270-20

Installing the IPS 4270-20 in the Rack

Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
•
•
•
Warning This procedure requires two or more people to position the IPS 4270-20 on the slide assemblies before
pushing it in to the rack.
To install the IPS 4270-20 in the rack, follow these steps:
Attach the chassis side rail to the IPS 4270-20 by aligning the chassis rail to the stud on the IPS 4270-20,
Step 1
pressing the chassis side rail in to the stud, and then sliding the chassis side rail backwards until you hear
the latch catch.
1
2
3
4
5
6
7
8
Note
Repeat Step 1 for each chassis side rail.
Step 2
OL-18504-01
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in
Statement 1006
the rack.
Cis co IPS
42 70 SER
IES
Int rus ion
Pre ven tio
n Se nso
r
The tapered end of the chassis side rail should be at the back of the IPS 4270-20. The chassis
side rail is held in place by the inner latch.
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
Installing the Rail System Kit
4-17