Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual page 129

Chapter 4 Installing the IPS 4270-20
Power
connector
PS2
UID
Attach the power cables (there are two power supplies) to the IPS 4270-20 and plug them in to a power
Step 6
source (a UPS is recommended).
Power on the IPS 4270-20.
Step 7
Initialize the IPS 4270-20.
Step 8
Upgrade the IPS 4270-20 with the most recent Cisco IPS software. You are now ready to configure
Step 9
intrusion prevention on the IPS 4270-20.
For More Information
For more information on working with electrical power and in an ESD environment, see
•
Safety Guidelines, page
For more information on the best place to position your sensor on the network, see
•
Topology, page
For the procedure for installing the IPS 4270-20 in a rack, see
•
Rack, page
For the instructions for setting up a terminal server, see
•
Server, page 1-19.
For the procedure for using the setup command to initialize the IPS 4270-20, see
•
Sensor, page
For the procedure for obtaining the most recent Cisco IPS software, see
•
Software, page
OL-18504-01
Sensing
interfaces
PCI-E x4 PCI-E x8 PCI-E x4 PCI-E x8
9 8 7 6 5
Reserved
1-30.
1-3.
4-17.
10-1.
11-1.
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
PCI-E x4 PCI-X 100 MHz
1
4 3 2
CONSOLE
Reserved
Console
Installing the IPS 4270-20 in the
Connecting an Appliance to a Terminal
Installing the IPS 4270-20
Power
connector
PS1
Reserved
for
Future Use
1
MGMT 0/0
Management0/0
port
Site and
Your Network
Initializing the
Obtaining Cisco IPS
4-37