Installing The Ips 4240-Dc - Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual

Installing the IPS 4240-DC

For More Information
•
•
•
•
•
•
•
•
•

Installing the IPS 4240-DC

The the IPS 4240-DC-K9 (NEBS-compliant) model equipped with DC-input power supply must be
terminated with the DC input wiring on a DC source capable of supplying at least 15 amps. A 15-amp
circuit breaker is required at the 48 VDC facility power source. An easily accessible disconnect device
should be incorporated into the facility wiring.
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
To ensure that all power is OFF, locate the circuit breaker on the panel board that services the DC
circuit, switch the circuit breaker to the OFF position, and tape the switch handle of the circuit
breaker in the OFF position.
The DC return connection should remain isolated from the system frame and chassis (DC-I). This
Note
equipment is suitable for connection to intra-building wiring only.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
2-10
DC power guidelines are listed in
Intrusion Detection and Prevention System 4200 Series Appliance
For more information on working with electrical power and in an ESD environment, see
Safety Guidelines, page 1-30.
For the procedure for placing IPS 4250-DC in a rack, see
For the instructions for setting up a terminal server, see
Server, page 1-19.
For the procedure for using the setup command to initialize IPS 4250-DC, see
page 10-4.
For the procedure for updating IPS-4250-DC with the most recent cisco IPS software, see
Cisco IPS Software, page
If you have the IPS 4240-DC model, see
For the procedure for using HTTPS to log in to IDM, refer to
For the procedures for configuring intrusion prevention on your sensor, refer to the following
documents:
Installing and Using Cisco Intrusion Prevention System Device Manager 7.0
–
Installing and Using Cisco Intrusion Prevention System Manager Express 7.0
–
Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface
–
7.0
Regulatory Compliance and Safety Information for the Cisco
11-1.
Installing the IPS 4240-DC, page
Chapter 2 Installing the IPS 4240 and the IPS 4255
Sensor.
Rack Mounting, page 2-6.
Connecting an Appliance to a Terminal
Basic Sensor Setup,
2-10.
Logging In to IDM.
Site and
Obtaining
OL-18504-01