Interfaces Information; Understanding The Show Interfaces Command; Interfaces Command Output - Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual

Intrusion prevention system appliance and module installation guide for ips 7.0
Table of Contents

Advertisement

Chapter A
Troubleshooting
The number of <evError> events written to the event store by severity
Fatal Severity = 0
Error Severity = 0
Warning Severity = 0
TOTAL = 0
The number of log messages written to the message log by severity
Fatal Severity = 0
Error Severity = 0
Warning Severity = 0
Timing Severity = 0
Debug Severity = 0
Unknown Severity = 0
TOTAL = 0
sensor#
The statistics all begin from 0.

Interfaces Information

The show interfaces command is useful for gathering information on the sensing and command and
control interfaces. This section describes the show interfaces command, and contains the following
topics:

Understanding the show interfaces Command

You can learn the following information from the show interfaces command:
The show interfaces command displays statistics for all system interfaces. Or you can use the individual
commands to display statistics for the command and control interface (show interfaces
command_control_interface_name), the sensing interface (show interfaces interface_name).

Interfaces Command Output

The following example shows the output from the show interfaces command:
sensor# show interfaces
Interface Statistics
Total Packets Received = 0
Total Bytes Received = 0
Missed Packet Percentage = 0
Current Bypass Mode = Auto_off
MAC statistics from interface GigabitEthernet0/1
Media Type = backplane
Missed Packet Percentage = 0
Inline Mode = Unpaired
Pair Status = N/A
OL-18504-01
Understanding the show interfaces Command, page A-87
Interfaces Command Output, page A-87
Whether the interface is up or down
Whether or not packets are being seen, and on which interfaces
Whether or not packets are being dropped by SensorApp
Whether or not there are errors being reported by the interfaces that can result in packet drops
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
Gathering Information
A-87

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents