Outgoing Authentication Protocol - ZyXEL Communications PRESTIGE 652H User Manual

FIELD
(min)
Period (hr)
Schedule Sets
Nailed up
Connection
Session Options
Edit Filter Sets
Idle Timeout (sec)
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.

28.2.3 Outgoing Authentication Protocol

For obvious reasons, you should employ the strongest authentication protocol possible. However, some
vendors' implementation includes specific authentication protocol in the user profile. It will disconnect if
the negotiated protocol is different from that in the user profile, even when the negotiated protocol is
stronger than specified. If the peer disconnects right after a successful authentication, make sure that you
specify the correct authentication protocol when connecting to such an implementation.
Remote Node Configuration
Table 28-1 Menu 11.1 Remote Node Profile
default for this field is 0 meaning no budget control.
This field is the time period that the budget should be reset. For
example, if we are allowed to call this remote node for a maximum of
10 minutes every hour, then the Allocated Budget is (10 minutes)
and the Period (hr) is 1 (hour).
This field is only applicable for PPPoE and PPPoA encapsulation.
You can apply up to four schedule sets here. For more details please
refer to the Call Schedule Setup chapter.
This field is only applicable for PPPoE and PPPoA encapsulation.
This field specifies if you want to make the connection to this remote
node a nailed-up connection. More details are given earlier in this
section.
Use [SPACE BAR] to choose Yes and press [ENTER] to open menu
11.5 to edit the filter sets. See the Remote Node Filter section for
more details.
Type the number of seconds (0-9999) that can elapse when the
Prestige is idle (there is no traffic going to the remote node), before
the Prestige automatically disconnects the remote node. 0 means
that the session will not timeout.
DESCRIPTION
Prestige 652 Series User's Guide
EXAMPLE
No
(default)
28-5