Table of Contents
Advertisement
Troubleshooting
Icons
LAN-Fax Operation Messages
If one of the messages listed below appears on the Windows display, follow the
instructions given here.
Message
Cannot connect to the
printer. If you select [Re-
try], the data will be sent to
the printer again.
10
The number of entries in
Destinations exceed the
limits.
Up to 100 entries can be
entered.
Up to 1500 characters can
be entered.
Please check.
"LAN-Fax" has already
been launched. Cannot
launch it again.
Failed to allocate memory. Available memory is insufficient.
164
Messages
Toner Almost Empty
Call Service Center
• No destination is programmed under the specified Quick Dial,
Speed Dial, or Group Dial code when using LAN-Fax trans-
mission. Click [Cancel].
Specify a Quick Dial, Speed Dial, or Group Dial code which the
destination is already programmed under and send the docu-
ment again, or program the destination under the Quick Dial,
Speed Dial, or Group Dial code.
• The memory limit was reached during a LAN-Fax transmis-
sion.
Click [Cancel] to cancel the transmission, and then divide the
document you want to send into parts for multiple transmis-
sions. If there are any documents in memory waiting to be sent
or printed with Substitute Reception, try to send the document
again after transmission or printing of these is complete.
• Check the network connection.
• Check the power of NIC FAX is turned on.
The number of destinations specified exceeds the limit. The maxi-
mum number of destinations that can be specified at one time is
100.
The total number of characters used for the specified destinations
exceeds the limit. The maximum number of characters that can be
entered is 1500.
The LAN-Fax dialog box is already open. Exit LAN-Fax once, and
then start it up again.
Causes and solutions
The toner level is low. Replace the toner cartridge
before the toner runs out.
See Chapter 4 "Replacing the Toner Cartridge", Ba-
sic Features.
Contact your service representative.
Causes and solutions
Advertisement
Table of Contents
