Table of Contents
Advertisement
If the Network Transmission Auto
Check Function Is Turned Off
If the Network Transmission Auto
Check function is set to "Off" with
user parameters, select IP-Fax
Transmission in the display that
appears. For information about
changing this setting, see p.166
"User Parameters" (switch 32, bit
1).
A Press the 0 0 0 0 or 1 1 1 1 key to select
"2. IP-Fax Address".
B Press the { { { { OK} } } } key.
H H H H
Enter the destination for IP-Fax-
ing you want to register.
Using IP Address or Host Name
A Enter the IP address or host
name you want to register.
If the Network Transmission
Auto Check function is set to
"On":
If the Network Transmission
Auto Check function is set to
"On":
Note
❒ IP addresses and host names
can contain up to 127 charac-
ters.
Registering Addresses for IP-Faxing
❒ When specifying a destina-
tion using IP address, you
may need to give the port
number too, depending on
network settings at the re-
ceiving end. For example, if
the destination IP address is
192.168.1.100 and the port
number is 2100, you should
identify the destination as
192.168.1.100:2100. Contact
your network administrator
for details.
❒ When specifying a destination
using host name, you may
need to give the port number
too, depending on network
settings at the receiving end.
For example, if the destination
host name is "abc.compa-
ny.com" and the port number
is 2100, you should identify
the destination as "abc.com-
pany.com:2100". Contact your
network administrator for de-
tails.
❒ When specifying a destina-
tion using host name, set the
DNS Server Address before-
hand.
B Press the { { { { OK} } } } key.
C Press the 0 0 0 0 or 1 1 1 1 key to select
"2. IP-Fax Address".
Note
❒ If the Network Transmission
A u t o C h e c k f u n c t i o n i s
turned off, the display does
not appear. Proceed to step
I
. See p.166 "User Parame-
ters" (switch 32, bit 1).
8
143
Advertisement
Table of Contents
