System > Smtp Service > Smtp Server Settings; System > Smtp Service > Smtp Service - D-Link DGS-1210-12TS/ME User Manual

4 Configuration
From Port / To Port: A consecutive group of ports may be configured starting with the selected port.
State: Enabled or Disabled the IEEE802.3az EEE for the specified ports. By default, all ports are enabled.
Click Apply to make the configurations take effect.
If the connection speed drops down from 1000M to 100M, or the first link up takes longer time, please follow
below steps and check again:
1. Upgrade drivers of your Ethernet adapter or LAN controller for the host PC.
2. Disable EEE function on the switch port
System > SMTP Service > SMTP Server Settings
The SMTP Service Settings page is used to configure the fields to set up the SMTP server for the switch,
along with setting e-mail addresses to which switch log file can be sent when a problem arises on the Switch.
User can Enabled or Disabled the SMTP State, then input the SMTP Server Address, SMTP Server Port,
Self Mail Address and Mail Receiver Address then click Apply button to configure.
SMTP State: Enabled or Disabled the SMTP service on this device.
SMTP Server Address: Select IPv4 or IPv6 and enter the IP address of the SMTP server on a remote
device. This will be the device that sends out the mail for user.
SMTP Server Port: Enter the virtual port number that the Switch will connect with on the SMTP server. The
common port number for SMTP is 25, yet a value between 1 and 65535 can be chosen.
Self Mail Address: Enter the e-mail address from which mail messages will be sent. This address will be the
"from" address on the e-mail message sent to a recipient. Only one self mail address can be configured for
this Switch. This string can be no more that 64 alphanumeric characters.
Mail Receiver Address: Enter a list of e-mail addresses so recipients can receive e-mail messages
regarding Switch functions. Up to 8 e-mail addresses can be added per Switch. Do delete these addresses
from the Switch, click Delete button from the Mail Receiver Address Table.
System > SMTP Service > SMTP Service
The SMTP Service is used to send test messages to all mail recipients configured on the Switch, thus testing
the configurations set and the reliability of the SMTP server.
DGS-1210 series Metro Ethernet Managed Switch User Manual
Figure 4.48 – System > IEEE802.3az EEE Settings
Figure 4.49 - System > SMTP Service > SMTP Server Settings
4
4
1
1