Smtp Server Commands; Enable Smtp; Disable Smtp - D-Link DES-1210-52/ME Cli Reference Manual

The SMTP Server commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

enable smtp

disable smtp

config smtp
show smtp
smtp sent_testmsg
Each command is listed in detail, as follows:
enable smtp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable SMTP feature on the Switch:
disable smtp
Purpose
Syntax
Description
Parameters
Restrictions
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
Parameter
[self_mail_addr <mail_addr 64> | server [<ipaddr> | <ipv6addr>] | server_port
<tcp_port_number 1-65535>] [{add mail_receiver <mail_addr 64>| delete
mail_receiver <index 1-8>}]
To enable the SMTP server feature on the Switch.
enable smtp
The enable smtp command enables the SMTP server feature on
the Switch.
None.
Only Administrator and Operator-level users can issue this
command.
DES-1210-52/ME:5# enable smtp
Command: enable smtp
Success.
DES-1210-52/ME:5#
To disable the SMTP server feature on the Switch.
disable smtp
The disable smtp command disables the SMTP server feature on
the Switch.
None.
Only Administrator and Operator-level users can issue this
command.

SMTP SERVER COMMANDS

36
6