Table of Contents
Advertisement
Comprehensive LED indicators display the conditions of the
Switch and status of the network. A description of these LED
indicators follows (see LED Indicators).
An RS-232 DCE console port is used to diagnose the Switch via
a connection to a PC and Local Console Management (TEG-
S224M and TEG-S224MF only).
Nineteen or 20 high performance NWay ports all operate at
10/100 Mbps for connection to servers and hubs. All ports can
be auto-negotiated between 10Mbps or 100Mbps.
A slide-in module slot (labeled Slot1) for 10/100 Mbps Ethernet
ports can accommodate the following modules: 2 -port TX, 2 -
port FX (MT-RJ), or 1-port FX (SC).
One or two MDI-II uplink jacks are supported. Port numbers 1
and 2 on the TEG-S224S and the TEG-S224SF are equipped
with MDI-X jacks for normal end-node connections and MDI-II
jacks for uplink connections.
S224M and TEG-S224MF are equipped with an MDI-X jack for
normal end-node connection and an MDI-II jack for uplink
connection.
Rear Panel
The rear panel of the TEG-S224S and the TEG-S224SF consist of a
slot (labeled Slot2) for a Stacking input/output port and an AC power
connector. The rear panel of the TEG-S224M and TEG-S224MF
consist of two slots (labeled Slot2 and Slot3). Slot2 is for Stacking
input/output ports Sio1, Sio2, and Sio3. Slot3 is for an optional
Gigabit Ethernet uplink (MDI-II) port. The following shows the rear
panel of the Switches.
Identifying External Components
Stackable NWay Ethernet Switch User's Guide
Port number 1 on the TEG-
13
Advertisement
Table of Contents
