Hardware Revision
hardware in the Switch unit.
Port
Select the port you want to configure by clicking on the port in
the Switch front panel display at the top of the screen or by
using the Switch, Slot, and Port fields at the bottom of the
screen. Then follow these steps:
1. Enable or disable the port in the State field. If you choose
Disable, devices connected to that port cannot use the
Switch, and the Switch purges their addresses from its
address table after the MAC address aging time elapses. The
Switch won't purge addresses if you define them as
permanent entries in the Static Forwarding Table.
128
Stackable NWay Ethernet Switch User's Guide
Version number of the module's
Figure 7-5. Configure Port window
Web-Based Network Management