Rear Panel; Understanding Led Indicators; Power And System Leds - TRENDnet TEG-448WS User Manual

The Reset button reset settings back to factory default.
Note: Please make sure you copy down or save settings before
pressing "Reset" button.

Rear Panel

The rear panel of the Switch consists of an AC power connector. The
following shows the rear panel of the Switch
Figure 5. Rear panel of the Switch
AC Power Connector:
Plug in the female connector of the provided power cord into this
connector. Connect the male into a power outlet. Supported input
voltages range from 100-240V AC at 50-60Hz.
11

UNDERSTANDING LED INDICATORS

The front panel LEDs provides instant status feedback for easy
monitoring and troubleshooting.
Figure 6. LED indicators of the Switch

Power and System LEDs

POWER: Power Indicator
On : When the Power LED is lit, the Switch is receiving power.
Off : When the Power LED is off, the switch is off.
System: Management Indicator
Blinking : When the Switch is working, the System LED blinks.
On/Off : The Switch is not working.
12