Table of Contents
Advertisement
Stackable NWay Ethernet Switch User's Guide
IP Address
Figure 7-1. Configure IP Address window
You can change the IP Address, Subnet Mask, and Default
Gateway on the Switch. If your are not using BOOTP, enter the IP
Address, Subnet Mask, and Default Gateway of the Switch. If
you enable BOOTP Service, you do not need to configure any IP
parameters because a BOOTP server automatically assigns IP
configuration parameters to the Switch. Click Apply to activate the
new settings.
The information above is described as follows:
Management Module MAC Address
address for the device. Also known as the physical address.
BOOTP Service The BOOTP protocol allows IP addresses,
subnet masks, and default gateways to be assigned on a
central BOOTP server. If this option is enabled, when the
Switch is first powered up it will look for a BOOTP server to
Web-Based Network Management
The Ethernet
123
Advertisement
Table of Contents
