Table of Contents
Advertisement
Stackable NWay Ethernet Switch User's Guide
Factory Reset
Before performing a Factory Reset, be absolutely certain that this
is what you want to do. Once the reset is done, all of the Switch's
settings stored in NV-RAM (including TCP/IP parameters, SNMP
parameters, the enabled/disabled settings of ports, security settings,
etc.) will be erased and restored to values present when the Switch
was purchased.
Note: After performing the Factory Reset, make sure to redefine
the IP settings for the Switch in the Configure IP Address
menu. Then perform a Restart System on the Switch. After
these three procedures are performed, your Factory Reset is
complete.
Choose Factory Reset from the main menu. The following
screen appears:
118
Figure 6-51. Restart System screen
Using the Console Interface
Advertisement
Table of Contents
