Table of Contents
Advertisement
All LED indicators will momentarily blink. This blinking of
the LED indicators represents a reset of the system.
The power LED indicator will blink while the Switch loads
onboard software and performs a self-test. After approximately
40 seconds, the LED will light continuously to indicate the
Switch is in a ready state.
The console LED indicator will remain ON if there is a
connection at the RS-232 port, otherwise this LED indicator is
OFF.
The 100M LED indicator may remain ON or OFF depending
on the transmission speed.
Power Failure
As a precaution, the Switch should be unplugged in case of power
failure. When power is resumed, plug the Switch back in.
Unpacking and Setup
Stackable NWay Ethernet Switch User's Guide
11
Advertisement
Table of Contents
