Table of Contents
Advertisement
Figure 3-3. Side panel views of the Switch
The system fans are used to dissipate heat. The sides of the
system also provide heat vents to serve the same purpose. Do
not block these openings, and leave adequate space at the rear
and sides of the Switch for proper ventilation. Be reminded
that without proper heat dissipation and air circulation,
system components might overheat, which could lead to
system failure.
Stack Operation
The TEG-S224M and the TEG-S224MF are intelligent Switches
capable of acting as a master for up to three client Switches (TEG-
S224S and TEG-S224SF). Each port is referred to by unit ID and
port number in your TEG-S224 Series stack.
To set up a stack, a one-port Stacking input/output module i s
needed for each client Switch and a three-port Stacking
input/output module is needed for the master Switch. Once the
modules have been installed, use a cascade cable to connect each
client Switch to the master Switch.
Identifying External Components
Stackable NWay Ethernet Switch User's Guide
15
Advertisement
Table of Contents
