Omron DEVICENET#05-2003 Operation Manual page 97

Transistor Output Units
Connector Pin Arrangement
Pin number
A20 A19
Function V
Pin number
B20 B19 B18
V
Function
Wiring
86
A18 A17 A16 A15 A14 A13
G OUT
OUT OUT OUT OUT OUT
15 14 13 12 11 10
B17 B16 B15 B14 B13 B12 B11
G OUT OUT OUT OUT OUT OUT
15 14 13 12 11 10
Attach a FUJITSU connector to the Transistor Output Unit and connect it to
external devices.
Applicable Connectors
Three types of connectors can be attached to the cable, depending on the
assembly method. When creating your own cables, use one of the following
connectors.
Manufacturer
FUJITSU
Connector Cables
When a Transistor Output Unit (high-density connector) is to be connected to
an OMRON I/O Block or a Connector-Terminal Block Conversion Unit, use the
cables (sold separately) listed in the following table.
Manufacturer
OMRON
Note V terminals and G terminals are internally connected. When the I/O power is
being supplied, the power can be supplied to the output devices from the V
and G connectors. Current supplied in this way, however, must be less than
2 A. If, instead of using the V and G connectors, the power supply is wired to
the terminal block as shown in the following diagram, the current supplied
must be less than 4 A.
A12 A11 A10 A9 A8 A7 A6
G
OUT OUT V OUT OUT OUT
09 08 07 06 05
B10 B9 B8 B7 B6
OUT OUT V G OUT OUT OUT
09 08 07 06 05
Model number
FCN361J040-AU
FCN363J040-AU
FCN367J040-AU/F
Model number
XW2Z-@@@B
G79-O@C-@
Output Unit
I/O Block (example)
A5 A4 A3 A2 A1
OUT OUT OUT OUT OUT m word
04 03 02 01 00
B5 B4 B3 B2 B1
OUT OUT OUT OUT OUT
m+1 word
04 03 02 01 00
Remarks
Soldered
Crimp
Pressure-welded
Corresponding device
Connector-Terminal Block Conversion Unit
XW2B-40G4
XW2B-40G5
I/O Block
G7TC-OC16, G7TC-OC08
G70D-SOC16, G70D-FOM16
G70A-ZOC16-3
M7F
Load
Section 4-4