Omron DEVICENET#05-2003 Operation Manual page 141

Analog Output Units
Components
I/O Unit Interface
Communications Connector 1
(on the Communications Unit side)
Internal Power Supply Terminals
Characteristics
Item
Output signal range
Allowable external out-
put load resistance
External output imped-
ance
Resolution
Accuracy 25 C
–10 C to
55 C
Conversion time
Converted output data
(Binary)
Dielectric strength
Isolation method
(Refer to page 200.)
TS Indicator
Shows the communications status of the I/O Unit interface.
Normal communications: Lit green
I/O Unit interface error:
During initialization, or with no power supply: Not lit
PWR Indicator
Internal power being supplied: Lit green
No internal power supply:
DIP Switch
(Refer to page 132.)
Pin 1 to 6: Output range
Pin 7:
Pin 8, 9:
Pin 10:
0 to 5 V, 1 to 5 V, 0 to 10 V, or –10 to 10 V (Current output
not possible)
5 K min.
0.5 max.
1/6000 (full scale)
0.4% FS
0.8% FS
4 ms/4 points
Binary
–10- to 10-V range: F448 to 0 to 0BB8 full scale
Other signal ranges: 0000 to 1770 full scale
500 VAC; detected current 1 mA (between communications
section and analog output, and between internal power
supply and analog output)
Photocoupler insulation (between communications part and
analog output)
(no insulation between analog outputs)
Lit red
Not lit
(Refer to page 201.)
U.ERR Indicator
Unit error: Lit red
Unit normal: Not lit
I/O Unit Interface
Communications Connector 2
(on the terminator side)
Analog Output Connectors
(made by MOLEX)
Connect to an analog output
devices.
DIN Track Mounting Hook
Reserved for system use (OFF)
Output for communications errors
Software setting enable/disable
Section 5-2
Specification
131