Omron DEVICENET#05-2003 Operation Manual page 135

Analog Output Units
Components
DIP Switch (Refer to page 125.)
On the left side of the Casette.
Pin 1 to 6: Output range
Pin 7: Reserved for system use (OFF)
Pin 8, 9: Output for communications errors
Pin 10: Software setting enable/disable
DIP Switch Settings
TS Indicator
Shows the communications status of the I/O Unit interface.
Normal communications: Lit green
I/O Unit interface error:
During initialization, or with no power supply: Not lit
I/O Unit Interface
Communications Connector 1
(on the Communications Unit side)
The following diagram shows the functions of the DIP switch.
The following table summarizes the DIP switch settings. (All pins are factory-
set to OFF.)
Pin(s)
1 through 6
7
8, 9
10
(Refer to page 200.)
Lit red
PWR Indicator
Internal power being supplied: Lit green
No internal power supply:
DIN Track Mounting Hook
Output Operating specifications
range
Output for communications errors
Software setting enable/disable
Function
Output range
Reserved for system use
Output for communications
errors
(See below.)
Software setting enable/
disable
Not lit
(Refer to page 201.)
U.ERR Indicator
Unit error: Lit red
Unit normal: Not lit
I/O Unit Interface
Communications Connector 2
(on the terminator side)
(Refer to page 207.)
Cassette
Detach by pressing on the lower
part and pulling outwards.
Terminal Block
ON
Settings
Output range settings (See below.)
OFF Must be set to OFF.
8 9 Output
OFF OFF Clear to minimum
(See below.)
OFF ON Clear to maximum
(See below.)
ON OFF Clear to 0 V
(for –10 to 10 V)
Clear to minimum
(other than the above)
ON ON Hold
OFF Set the output range and
output for communications
errors with pins 1 to 9. (fac-
tory-set)
ON Output range setting (See
note.) and output setting for
communications errors can
be set using the Configura-
tor.
Section 5-2
Meaning
125