Omron DEVICENET#05-2003 Operation Manual page 37

Specific Example
24
b) You must also use the DIP switch and the Configurator to set the
Temperature Input Unit. For details, refer to 5-3 GT1-TS04T and
GT1-TS04P Temperature Input Units.
Operating specifications
Temperature unit
Number of decimal places used
Enable/disable software settings
6. Connect to the DeviceNet Master Unit.
Communications
Unit
7. Turn ON the power.
8. Set using the Configurator.
Using version 1.11 or later versions of the DeviceNet Configurator, it is
possible, via the network, to set the following:
• Input range for Analog Input Units.
• Output range for Analog Output Units.
• I/O Unit interface error output (low-clear output/high-clear output) for
Analog Output Units.
Note a) When using a DIP switch, the input and output ranges for the An-
alog Input and Output Units can be set in 2-point units, whereas
with a Configurator, a setting can be made for each point.
b) You can set the Temperature Input Unit input range as well as the
I/O Unit settings using the Configurator. For details, refer to 5-3-2
Settings Using the Configurator.
9. Create the scan list.
Set the Scan List Enable switch (PC software switch) to ON. For example,
for a DeviceNet Master Unit with unit address 0 installed in a C200HX/HG/
Temperature Input Unit
Left side of
cassette
Input type
Input range
Communications
power supply
24 VDC DeviceNet Network
I/O Unit
Section 2-2