Omron DEVICENET#05-2003 Operation Manual page 88

Transistor Output Units
Connector Pin Arrangement
Wiring Attach a FUJITSU connector to the Transistor Output Unit and connect to
external devices.
Applicable Connectors
Three types of connectors can be attached to the cable, depending on the
assembly method. When creating your own cables, use one of the following
connectors.
Manufacturer
FUJITSU
Connector Cables
When a Transistor Output Unit (connector) is to be connected to an OMRON I/
O Block or a Connector-Terminal Block Conversion Unit, use the cables (sold
separately) listed in the following table.
Manufacturer
OMRON
Note V terminals and G terminals are internally connected. When the I/O power is
being supplied, the power can be supplied to the output devices from the V
and G connectors. Current supplied in this way, however, must be less than
2 A. If, instead of using the V and G connectors, the power supply is wired to
the terminal block as shown in the following diagram, the current supplied
must be less than 2.5 A.
Pin number
A12 A11 A10 A9 A8
Function
G
V NC V OUT
07
Pin number
B12 B11 B10 B9 B8
G
V NC V OUT
Function
15
Model number
FCN361J024-AU
FCN363J024-AU
FCN367J024-AU/F
Model number
XW2Z-@@@A
G79-@@@C
Output Unit
I/O Block (example)
A7 A6 A5 A4 A3 A2
OUT OUT OUT OUT OUT OUT OUT
06 05 04 03 02 01
B7 B6 B5 B4 B3 B2
OUT OUT OUT OUT OUT OUT OUT
14 13 12 11 10 09
Remarks
Soldered
Crimp
Pressure-welded
Corresponding device
Connector-Terminal Block Conversion Unit
XW2B-20G4
XW2B-20G5
I/O Block
G7TC-OC16
G70D-SOC16
G70D-FOM16
G70A-ZOC16-3
M7F
Load
Section 4-4
A1
00
B1
08
77