Specifications - Omron CQM1H - PROGRAM Programming Manual

High-speed Counter Board
2-1-6

Specifications

Instructions
Related Control Bits, Flags, and Status Information
Word
Slot 1 Slot 2
IR 200 IR 232
IR 201 IR 233
IR 202 IR 234
IR 203 IR 235
IR 204 IR 236
IR 205 IR 237
IR 206 IR 238
IR 207 IR 239
IR 208: IR 240:
Counter 1 Counter 1
IR 209: IR 241:
Counter 2 Counter 2
IR 210: IR 242:
Counter 3 Counter 3
IR 211: IR 243:
Counter 4 Counter 4
66
Instruction
CTBL(63)
INI(61)
PRV(62)
Bits
00 to 15 Counter 1 PV (rightmost four digits) The PV of the high-speed counter on each
00 to 15 PV (leftmost four digits)
00 to 15 Counter 2 PV (rightmost four digits)
00 to 15 PV (leftmost four digits)
00 to 15 Counter 3 PV (rightmost four digits)
00 to 15 PV (leftmost four digits)
00 to 15 Counter 4 PV (rightmost four digits)
00 to 15 PV (leftmost four digits)
00 to 07 Comparison Results: Internal Output
Bits 00 to 07
08 to 11 Comparison Results: Bits for External
Outputs 1 to 4
12 Counter Operating Flag
13 Comparison Flag
14 PV Overflow/Underflow Flag
15 SV Error Flag
Used to register target or range comparison tables or used to start
comparisons for previously registered comparison tables. A table
can be registered and comparison started with separate instruc-
tions or the same instruction.
Used to start or stop comparison using registered comparison
table or used to change the PV of a high-speed counter.
Used to read the PV or status of a high-speed counter.
Name
port of the High-speed Counter Board is
stored after each cycle.
Note The form in which data is stored
Contains the bit pattern specified by oper-
and in CTBL(63) when a condition is satis-
fied.
Contains the bit pattern specified by oper-
and in CTBL(63) when a condition is satis-
fied.
0: Stopped
1: Operating
Indicates whether or not a comparison is in
progress.
0: Stopped
1: Operating
Indicates whether or not an overflow or
underflow has occurred.
0: Normal
1: Overflow or underflow has occurred
0: Normal
1: Setting error
Section 2-1
Meaning
Function
(BCD or hexadecimal) can be spec-
ified in the PC Setup (DM 6602 and
DM 6611).