Omron CQM1H - PROGRAM Programming Manual page 129

Pulse I/O Board
25313 (Always ON)
25313 (Always ON)
25313 (Always ON)
104
In addition, the following data is stored for the comparison table:
DM 0000: 0003 — Number of target values: 3
DM 0001: 2500 — Target value 1: 2,500
DM 0002: 0000
DM 0003: 0100 — Comparison 1 interrupt processing routine No.: 100
DM 0004: 7500 — Target value 2: 7,500
DM 0005: 0000
DM 0006: 0101 — Comparison 2 interrupt processing routine No.: 101
DM 0007: 0000 — Target value 3: 10,000
DM 0008: 0001
DM 0009: 0102 — Comparison 3 interrupt processing routine No.: 102
00000
@CTBL(63)
DM 0000
@PULS(65)
@SPED(64)
#0001
@ACC(−−)
DM 0010
SBN(92)
10000
RET(93) RET(93)
SBN(92)
@ACC(−−)
DM 0012
RET(93)
RET(93)
SBN(92)
SPED(64)
#0000
RET(93) RET(93)
Specifies port 1, saves the comparison
table in target value format, and begins
001
comparing.
000
Sets CW pulses for port 1. (Number of
pulses not set.)
001
004
000
Begins continuous pulse output from port
1 at frequency unit of 10 Hz.
001
001
ACC(−−) mode 1 accelerates the fre-
quency to 25 kHz at about 500 Hz/4 ms.
001
DM 0010: 0050 500 Hz acc./4 ms.
001
DM 0011: 2500 Target value 25 kHz.
100
Turns ON IR 10000.
101
ACC(−−) mode 3 decelerates the fre-
quency to 500 Hz at about 500 Hz/4 ms.
001
DM 0012: 0050 500 Hz acc./4 ms.
003
DM 0013: 0050 Target value: 500 Hz.
102
Pulse output from port 1 is stopped by set-
ting the frequency to 0.
001
001
Section 2-2