Column-To-Line - Line - Omron CQM1H - PROGRAM Programming Manual

Programmable controllers; inner boards

Table of Contents

Conversion Instructions

5-20-15 COLUMN-TO-LINE – LINE(––)

0 0 0 0 1 1 1 0 0 0 1 0 0 0 0 1

1 1 0 1 0 0 1 0 0 1 1 1 0 0 0 1

0 0 0 1 1 0 1 1 0 0 1 0 0 1 1 1

1 0 0 0 0 0 1 1 0 0 0 0 0 1 1 1

0 1 1 1 0 0 0 1 1 0 0 0 1 0 1 0

Ladder Symbols

S and S+15 must be in the same data area.

C must be BCD between #0000 and #0015.

DM 6144 to DM 6655 cannot be used for D.

When the execution condition is OFF, LINE(––) is not executed. When the

execution condition is ON, LINE(––) copies bit column C from the 16-word set

(S to S+15) to the 16 bits of word D (00 to 15).

The column bit designator C is not BCD, or it is specifying a non-exis-

tent bit (i.e., bit specification must be between 00 and 15).

Indirectly addressed EM/DM word is non-existent.

(Content of *EM/*DM word is not BCD, or the EM/DM area boundary

has been exceeded.)

S and S+15 are not in the same data area.

ON when the content of D is zero; otherwise OFF.

The following example shows how to use LINE(––) to move bit column 07

from the set (IR 100 to IR 115) to DM 0100.

S: First word of 16 word source set

IR, SR, AR, DM, EM, HR, TIM/CNT, LR

C: Column bit designator (BCD)

IR, SR, AR, DM, EM, HR, TIM/CNT, LR, #

IR, SR, AR, DM, EM, HR, TIM/CNT, LR

Address Instruction

Section 5-20

Operand Data Areas

D: Destination word

Chapters

Table of Contents