Omron CQM1H - PROGRAM Programming Manual page 71

Pulse Output Function
No. of pulses
Ladder Program
SET PULSES
Set the number of out-
put pulses (8-digit BCD.)
MODE CONTROL
Stop the pulse output.
PC Setup Settings
Continuous Pulse Output
Setting the Number of
Pulses
46
Frequency
Ladder Program
SPEED OUTPUT
Set the output mode (continuous or
independent.)
Set the pulse frequency (20 Hz to 1
kHz.)
Start the pulse output.
Before executing SPED(64) to output pulses from an Output Unit, set the PC
to PROGRAM mode and make the following settings in the PC Setup.
In DM 6615, specify the output word that will be used for SPED(64) pulse out-
put to Output Units. (The bit is specified in the first operand in SPED(64).)
The content of DM 6615 (0000 to 0015) specifies output words IR 100 to
IR 115. For example, if DM 6615 is set to 0002, pulses will be output to
IR 102.
Output word (rightmost 2 digits, BCD): 00 to 15
Default: Pulse output to IR 100.
Pulses will begin to be output at the specified output bit when SPED(64) is
executed. Set the output bit from 00 to 15 (D=000 to 150) and the frequency
from 20 Hz to 1000 Hz (F=0002 to 0100). Set the mode to continuous mode
(M=001).
Execution condition
The pulse output can be stopped by executing INI(61) with C=003 or execut-
ing SPED(64) again with the frequency set to 0. The frequency can be
changed by executing SPED(64) again with a different frequency setting.
The total number of pulses that will be output can be set with PULS(65) before
executing SPED(64) in independent mode. The pulse output will stop auto-
matically when the number of pulses set by PULS(65) have been output.
Execution condition
Transistor pulse output
(from an Output Unit allocated a
word between IR 100 and IR 115)
Each cycle
Pulse output status
15
Bit
0 0
DM 6615
Always 00
@SPED(64)
@PULS(65)
Section 1-5
Pulse
output
PC Setup
DM 6615
bits 00 to 07
0
D
M
F
000
000
P1