Wiring Cnp1, Cnp2, And Cnp3 - Mitsubishi Electric MELSERVO MR-J5 Series User Manual

Wiring CNP1, CNP2, and CNP3

• For the wire sizes, refer to the following.
Page 326 Selection example of wires
• When wiring, remove the power connectors from the servo amplifier.
• Insert only one wire or ferrule into each wire insertion hole on each power connector.
To wire to CNP1, CNP2, and CNP3, use the servo amplifier power connectors that came with the amplifier.
Connector
MR-J5-10_ to MR-J5-100_
CNP1
CNP2
CNP3
Connector Receptacle assembly
CNP1 06JFAT-SAXGDK-K7.5 (LA)
CNP2 05JFAT-SAXGDK-K5.0 (LA)
CNP3 03JFAT-SAXGDK-K7.5 (LA)
MR-J5-200_/MR-J5-350_
CNP1
CNP2
CNP3
Connector Receptacle assembly
CNP1 06JFAT-SAXGFK-XL (LA)
CNP2 05JFAT-SAXGDK-H5.0 (LA)
CNP3 03JFAT-SAXGFK-XL (LA)
3 SIGNALS AND WIRING
80
3.3 Explanation of power supply system
Applicable wire
Size Insulator OD
18 to 14 AWG 3.9 mm or less
Applicable wire
Size Insulator OD
16 to 10 AWG 4.7 mm or less
18 to 14 AWG 3.9 mm or less
16 to 10 AWG 4.7 mm or less
Stripped length Open tool
[mm]
9 J-FAT-OT-K
Stripped length Open tool
[mm]
11.5 J-FAT-OT-EXL
9
11.5
Manufacturer
JST
Manufacturer
JST