6.23
SCC 15-F Shield connection clamp
This component is a terminal block for grounding the shield of the servo motor power cable on the top of the servo amplifier.
For details of the component, contact Phoenix Contact.
To install the component, two screws of M4 × 6 to 12 are required.
Compatible models
• MR-J5-500_4_/MR-J5-700_4_
Applicable wire diameter
• 8 mm to 15 mm
Cable connection method
Peel a part of the cable insulator to expose the external conductor as shown in the following figure, and secure that part by
putting it into the shield connection clamp.
External conductor
6 OPTIONS AND PERIPHERAL EQUIPMENT
410
6.23 SCC 15-F Shield connection clamp
Cable
Shield
connection clamp
Strip the cable insulator
of the clamped area.
40 mm
Cutter
Cable