Attach The Large Hoop Support; Removing The Embroidery Unit Extension And Large Hoop Support - Husqvarna VIKING Designer Epic 3 User Manual

Attach the Large Hoop Support

There are two large hoop supports, one for the front and one
for the back of the embroidery unit extension. One side of
the hoop supports is slightly more angled than the other, the
more angled side should be placed to the left.
1. Fold out the feet on the large hoop support.
2. Align the straighter edge of the hoop support with the
right edge of the embroidery unit extension.
3. Place the hooks (placed on the underside) of the hoop
support around the embroidery unit extension and push
the hoop support onto the extension until it clicks in
place. Repeat for the rear hoop support.
Removing the Embroidery Unit Extension
and Large Hoop Support
Note: Remove the large hoop support first, before removing the
embroidery unit extension.
Fold in the legs (1) of the large hoop supports and tilt slightly
downwards (2) to release it from the embroidery unit
extension (3).
Push the embroidery unit extension slightly to the left. Once
released, carefully remove it from the free arm and
embroidery unit.
52
1
2
3
3 Embroidery Preparations
2
3
1