Embroidery Stitch-Out Pop-Up Messages; Embroidery Unit Calibration; Attach Correct Hoop - Husqvarna Designer Diamond User Manual

Embroidery Stitch-Out
Embroidery Stitch-Out pop-up
messages

Embroidery unit calibration

When the embroidery unit is attached, a pop-up message
asks you to slide off the hoop and clear the machine
area for calibrating the embroidery arm. You will also be
reminded to snap on the embroidery presser foot R.
Note: It is very important to remove the hoop, otherwise the hoop or
the embroidery unit may be damaged while calibrating.

Attach correct hoop

If the size of the hoop attached to the machine does not
match the size displayed on screen, the machine will not
embroider. You must change the hoop to the displayed
size or change the hoop setting to match the hoop size
attached.
The hoop needs to be inserted properly for the machine
to detect it. Slide the hoop connector into the hoop
attachment from front to back until it clicks into place.
You will not be able to go to Embroidery Stitch-Out
without the selected hoop attached properly.
Bobbin empty
When the bobbin is almost empty, the machine stops
automatically and a pop-up message appears on the screen.
Note: It is possible to embroider until the thread has completely run
out. Press the Start/Stop button to continue embroidering without
closing the bobbin empty pop-up message.
Close the pop-up message. Replace the empty bobbin
with a full one and pull back excess needle thread. Start
embroidering again by pressing the Start/Stop button or
the foot control.
Note: Use Bobbin Position to get easier access to the bobbin. When
the bobbin is replaced, touch Current Stitch Position to move the hoop
back to where the embroidery stopped.
Check needle thread
The machine stops automatically if the needle thread runs
out or breaks. Re-thread the needle thread, close the pop-
up message, go back a few stitches using the Step Stitch-by-
Stitch control and start embroidering again.
8:11