Getting Started With Sequence; Directional Stitches - Husqvarna VIKING Designer Epic 3 User Manual

Getting Started with Sequence

To start creating a sequence, select a desired stitch and/or
letter and add it to the sequence. The active position is
marked by a cursor and the selected stitch or letter will be
highlighted. Only the selected stitch/stitches can be adjusted.
Inserted stitches will be placed at the cursor position.
Touch select multiple to select several stitches in a sequence.
Touch select all to select all stitches.
Move the cursor through the sequence using the arrows. The
number of selected stitch and total number of stitches in the
sequence are shown between the arrows. When sewing a
sequence it is possible to start sewing anywhere in the
sequence. Use the arrows to step through the sequence.
Note: Buttonholes and 4–way stitches cannot be programmed.

Directional Stitches

Add directional stitches between stitches in a sequence.
These stitches makes it possible to move stitches in various
directions and you can create new shapes and wider large-
area borders.
Directional stitches are straight stitches with a length of
approximately 1mm and can be used in 16 different
directions.
Touch your intended angle and one stitch will be inserted in
the sequence at the cursor position.
The directional stitch can be deleted, duplicated or mirrored
without closing the directional stitches pop-up.
11 Sequence 133