Husqvarna VIKING Designer Epic 3 User Manual page 19

Side-Motion Foot S
Used for side-motion/omnimotion stitches.
Sensor One-Step Buttonhole Foot
Plug into the machine then enter the desired buttonhole length to sew sensor one-step
buttonholes. The middle guideline measures ½" (12mm) from the needle position. The two
tunnels on the underside of the foot ensure smooth feeding over the buttonhole columns. The
finger on the back of the foot holds cording for corded buttonholes.
Self-Adhesive Glide Plates
If sewing on foam, vinyl, plastic, or leather, the material can stick to the foot and prevent the
sewing machine from feeding properly. When using any of the above materials, sew on a piece of
scrap fabric, to make sure the machine feeds smoothly. If not, fasten the self-adhesive glide plate
to the underside of the presser foot.
1 Introduction 19