Clearance Between Needles Support And Needle - Needles (C) And (D) - Husqvarna VIKING HUSKYLOCK 936 Service Manual

5. CLEARANCE BETWEEN NEEDLES SUPPORT AND NEEDLE
- NEEDLES (C) AND (D)
CHECK
When needle is in its lower turning position, the right hand needle should not
touch the needle support (K,L) at any point.
Valid for Schmetz #80.
ADJUSTMENT
1.Loosen screws (O) of the needle support and turn it until its clearance (M)
to the needle is between 0-0.10 mm.
2. Tighten screw (O).
K= Front needle support.
L= Rear needle support.
10 Husqvarna Viking Huskylock 936 104 72 49-26