Husqvarna VIKING Designer Epic 3 User Manual page 90

Bobbin Thread Low
When the bobbin thread is running low, a pop-up message
appears giving you notice that you will soon need to replace
the bobbin. If you want to continue sewing without replacing
the bobbin, touch the foot control and do not close the pop-
up.
When the bobbin is replaced with a full one, touch OK in the
pop-up.
Stitch Width Safety
When stitch width safety is activated, the following pop-up
message appears when you choose a stitch not suitable for
stitch width safety.
Cannot Use the Automatic Needle Threader
If using a twin needle, touch OK and thread it manually. If
using a regular needle, touch OK and deselect twin needle in
the settings. Press the automatic needle threader button again.
Remove Sensor One-Step Buttonhole Foot
The Sensor One-Step Buttonhole Foot needs to be removed
before doing any of the following:
• Sewing a stitch that is not a buttonhole.
• Sewing a buttonhole that can not be sewn with the Sensor
One-Step Buttonhole Foot.
• Sewing an adjusted buttonhole saved without the Sensor
One-Step Buttonhole Foot in the mySewnet cloud folder.
90
Check Upper Thread
The machine stops automatically if the upper thread runs out
or breaks. Re-thread the upper thread, close the pop-up
message and start sewing.
Attention!
If the machine stops and this pop-up appears on the screen
you need to stop sewing. Wait a moment and touch OK when
it is enabled. Check the needle size and condition. Check for
correct threading.
Twin Needle
The following pop-up message appears when you choose a
stitch not suitable for twin needle.
7 Sewing